Kia Optima: Inspection
1. |
Check the bushing for wear and
deterioration. |
2. |
Check the rear lower arm for
deformation. |
3. |
Check the coil spring and spring
pad for deterioration and deformation. |
4. |
Check for all bolts and nut. |
1.
Installation is the reverse of
removal.
•
If you don't
...
See also:
Reassembly
1.
Install the hub bearing to the
knuckle assembly.
(1)
Lay the knuckle assembly
(A) on press.
(2)
Lay a new hub bearing
upon the k ...
Driving in flooded areas
Avoid driving through flooded areas unless you are sure the water is no higher
than the bottom of the wheel hub. Drive through any water slowly. Allow adequate
stopping distance because brake perf ...
Fuel Filler Door Release Actuator. Repair procedures
Inspection
1.
Remove the trunk room left side
trim.(Refer to the BD group - "Interior trim")
2.
Remove the fuel filler door release
actuator (A) after ...