Kia Optima: Inspection
[Motor]
1. |
Turn ignition switch OFF.
|
2. |
Disconnect the EWGA connector.
|
3. |
Check that the EWGA is stuck by foreign material.
|
4. |
Measure resistance between motor (+) and (-) control
terminals of the motor.
|
5. |
Check that the resistance is within the specification.
Specification:
Refer to “Specification” section.
|
|
[Position Sensor]
1. |
Turn ignition switch ON. |
2. |
Connect the GDS to the data link connector(DLC). |
3. |
Check the output voltage at each position of the
EWGA position sensor on current data item within the specification.
Specification:
Refer to “Specification” section.
|
|
1.
Turn the ignition switch OFF and disconnect the battery
negative (-) cable.
2.
Disconnect the EWGA connector (A).
3.
Remove the shaft ...
See also:
Removal and Installation
1.
Disconnect the terminals from the battery.
Tightening torque
:(+) terminal (A) : 7.8 ~ 9.8N.m (0.8 ~ 1.0kgf.m,
5.8 ~ 7.2lb-ft)
(-) terminal (B) : 4.0 ...
Components and Components Location
Components Location
1. Engine Control Module (ECM)
2. Manifold Absolute Pressure Sensor (MAPS) #1
3. Intake Air Temperature Sensor (IATS)
4. Manifold Absolute Pressure Sensor ...
How to use this manual
We want to help you get the greatest possible driving pleasure from your vehicle.
Your Owner’s Manual can assist you in many ways. We strongly recommend that you
read the entire manual. In order t ...