Kia Optima: Inspection
1. |
Turn the ignition switch OFF. |
2. |
Disconnect the OTS connector. |
4. |
After immersing the thermistor of the sensor into
engine coolant, measure resistance between the OTS terminals 1 and 2. |
5. |
Check that the resistance is within the specification.
Specification:
Refer to “Specification”
|
|
1.
Turn the ignition switch OFF.
2.
Disconnect the OTS connector (A).
3.
Remove the OTS.
...
See also:
Replacement
1.
Disconnect the negative (-) battery
terminal.
2.
Remove the crash pad.(Refer
to BD group - "Crash Pad")
3.
Disconnect the Intake actu ...
Troubleshooting
Troubleshooting
Symptom
Possible cause
Remedy
Tachometer does not operate
Cluster fuse (10A) blown
Check for short and replac ...
Measuring Body Dimensions
1.
Basically, all measurements
in this manual are taken with a tracking gauge.
2.
When a measuring tape is
used, check to be sure there is no elongation, twis ...