During programming, your hand-held transmitter may automatically stop transmitting.
Continue to press and hold the HomeLink button while you press and repress ("cycle") your handheld transmitter every two seconds until the frequency signal has been learned. The indicator light will flash slowly at first and then rapidly upon successful training.
✽ NOTICE
If programming a garage door opener or gate, it is advised to unplug the device during the "cycling" process to prevent possible motor burnout.
Inspection
1.
Turn ignition switch OFF.
2.
Disconnect the oil temperature
sensor connector.
3.
Measure resistance between sensor
signal terminal and sensor g ...
Mode selection
The mode selection button controls the direction of the air flow through the
ventilation system
Face-Level (B, C,
D, E, F)
Air flow is directed toward the upper body and face. Additionally, ea ...
Automatic turn off function
The interior lights automatically turn off approximately 20 minutes after the
ignition switch is turned off.
If your vehicle is equipped with the theft alarm system, the interior lights
automatic ...