Kia Optima: Front Bumper. Repair procedures
Replacement
| • |
Put on gloves to protect
your hands. |
| • |
Use a plastic panel removal
tool to remove interior trim pieces to protect from marring the
surface. |
| • |
Take care not to bend
or scratch the cover and other parts. |
|
| 1. |
After loosening the mounting
bolts and clips, then remove the radiator grill upper cover (A).
|
| 2. |
After loosening the front bumper
side mounting screw, disconnect the side.
|
| 3. |
Remove the front bumper by pulling
up the side of the front bumper and then pull it out.
| •
|
When you pull
out the front bumper, the side part of the front bumper
could be damaged by the projection (A). |
|
|
| 4. |
Remove the front bumper lower
mounting clips.
|
| 5. |
Disconnect the fog lamp connectors
(A). |
| 6. |
Remove the front bumper.
|
| 7. |
Installation is the reverse of
removal.
| •
|
Replace any damaged
clips. |
| •
|
Make sure the
connector is plugged in properly. |
|
|
1. Front bumper cover
2. Front bumper lip assembly
3. Radiator grill
4. Front bumper lower side molding
5. Front fog lamp
6. Wiring harness assembly
7. Front b ...
See also:
Floor mat anchor(s)
When using a floor mat on the front floor carpet, make sure it attaches to the
floor mat anchor(s) in your vehicle. This keeps the floor mat from sliding forward.
WARNING
The following must be ...
Inspection
1.
Turn ignition switch OFF.
2.
Disconnect the oil temperature
sensor connector.
3.
Measure resistance between sensor
signal terminal and sensor g ...
EPB Switch. Repair procedures
Remove
1.
Turn ignition OFF and disconnect
the negative (-) battery cable.
2.
Remove the floor console upper
cover.(Refer to Body group - "Console")
...
Components(2)