Kia Optima: Disassembly
| 1. |
Disconnect the M-terminal (A) on the magnet switch
assembly (B). [REMY]
|
![[VALEO]](images/books/849/syfee0005n.gif)
| 2. |
After loosening the screws (A), detach the magnet
switch assembly (B). [REMY]
|
![[VALEO]](images/books/849/syfee0006n.gif)
| 3. |
Loosen the through bolts (A). [REMY]
|
![[VALEO]](images/books/849/syfee0007n.gif)
| 4. |
Remove the brush holder assembly (A), yoke (B) and
armature (C). [REMY]
|
![[VALEO]](images/books/849/syfee0008n.gif)
| 5. |
REMY : Remove the lever plate (B) and lever packing
(A).
|
| 6. |
Remove the packing (A) and shield (B). (REMY only)
|
| 7. |
Disconnect the planet gear (A). (REMY only)
|
| 8. |
Disconnect the planet shaft assembly (or reducer
assembly) (A) and lever (B). [REMY]
|
![[VALEO]](images/books/849/syfee0011n.gif)
| 9. |
Press the stopper (A) using a socket (B).
|
| 10. |
After removing the stop ring (A) using stop ring
pliers (B).
|
| 11. |
Disconnect the stopper (A), overrunning clutch (B),
internal gear (C), planet shaft (or drive shaft) (D) and/or gasket sheet
(E). [REMY]
|
![[VALEO]](images/books/849/syfee0205n.gif)
| 12. |
Reassembly is the reverse of disassembly.
|
Removal and Installation
1.
Remove the engine cover.
2.
Disconnect the battery negative terminal (A).
Tightening torque
:4.0 ~ 6.0N.m (0.4 ~ 0.6kgf.m, 3.0 ~ 4.4lb-ft) ...
Inspection
Armature Inspection
And Test
1.
Remove the starter.
2.
Disassemble the starter as shown at the beginning
of this procedure.
...
See also:
Cargo net
To keep items from shifting in the trunk, you can use the four rings located
in the trunk to attach the cargo net.
CAUTION
Do not put fragile, bulky or excessive items into cargo net. The i ...
Power Steering
Power steering uses energy from the engine to assist you in steering the vehicle.
If the engine is off or if the power steering system becomes inoperative, the vehicle
may still be steered, but it ...
Overhead Console Lamp. Schematic Diagrams
Circuit Diagram
...
Copyright © www.kiopman.com 2024