1. |
Remove the alternator cover (A) using a screw driver
after loosening the nuts (B).
|
2. |
Remove the slip ring guide (A) and then loosen the
mounting bolts and disconnect the brush holder assembly (B).
|
3. |
Remove the pulley (A) using the SST (09373-27000)
(B).
|
4. |
Loosen the 4 through bolts (A).
|
5. |
Disconnect the rotor (A) and cover (B).
|
6. | Reassembly is the reverse order of disassembly. |
Tire specification and pressure label
The tires supplied on your new vehicle
are chosen to provide the best performance
for normal driving.
The tire label located on the driver's side
center pillar gives the tire pressures reco ...
Tightening Torque
Items
N.m
Kgf.m
lb-ft
Front and rear doors
Door hinge to body
34.3 ~ 41.2
3.5 ~ 4.2
25.3 ~ 30.4 ...
Parking Brake
• To set the parking brake, pull the parking brake handle fully and firmly upward
while applying the service brake.
• To release the parking brake, pull the handle up slightly and push the rele ...