2.4 engine
2.0 engine
1. Be sure the vehicle is on level ground.
2. Start the engine and allow it to reach
normal operating temperature.
3. Turn the engine off and wait for a few
minutes (about 5 minutes) for the oil to
return to the oil pan.
4. Pull the dipstick out, wipe it clean, and
re-insert it fully.
WARNING - Radiator hose
Be very careful not to touch the radiator hose when checking or adding the engine oil as it may be hot enough to burn you.
5. Pull the dipstick out again and check the level. The level should be between F and L.
CAUTION
2.4 engine
2.0 engine
If it is near or at L, add enough oil to bring the level to F. Do not overfill.
Use a funnel to help prevent oil from being spilled on engine components.
Use only the specified engine oil. (Refer to “Recommended lubricants and capacities” in section 8.)
Installation
1.
Installation is the reverse of
removal.
2.
Tighten the HECU mounting bolts
and nuts to the specified torque.
3.
After installation, bleed the
b ...
Instrument Cluster. Components and Components Location
Components
...
General
1.
Basically, all measurements in
this manual are taken with a tracking gauge.
2.
When a measuring tape is used,
check to be sure there is no elongation, twisting or ...