1. Raise and suitably support the vehicle.
2. Remove the drain plug on the bottom of the transaxle.
3. After the oil has drained completely, install a new washer on the plug, reinstall
the drain plug and tighten to 22 lb•ft (30 N•m).
4. Remove the fill/check plug on the side of the transaxle.
5. Add oil through the fill/check hole until it reaches the bottom of the fill/check
hole.
6. Install a new washer on the fill/check plug.
7. Reinstall and tighten the fill/check plug to 22 lb•ft (30 N•m).
Use only the specified manual transaxle oil. (Refer to “Recommended Lubricants’’ later in this section.)
Inspection
Speed Operation Check
1.
Remove the connector (A) from
the wiper motor.
NO
Description
NO
Description
...
Installation
1.
Install the rear combination
lamp (Inside) assembly.
2.
Install the rear combination
lamp (outside) assembly.
...
Audio Unit. Components and Components Location
Components
...