Kia Optima: Battery
Sensor. Description and Operation
Description
Vehicles have many control units that use more electricity.
These units control their own system based on information from diverse sensors.
It is important to have a stable power supply as there diverse sensors giving
a variety of information. Battery sensor is mounted on battery (-) terminal.
It transmits battery voltage, current, temperature information to ECM. ECM controls
generating voltage by duty cycle based on these signals.

When battery sensor signal fault occurs, inspect
the vehicle parasitic draw in advance after inspecting the sensor because
the sensor will behave abnormally when the parasitic draw is more than
100mA. (Refer to vehicle parasitic current inspection) |
Perform the following process after replacing the
battery sensor.
1. |
Ignition switch ON/OFF. |
2. |
Park the vehicle about 4 hours. |
3. |
After 4 hours later, check the SOC (State
of charge) of battery using GDS. |
|
For the vehicle equipped with a battery sensor, be
careful not to damage the battery sensor when the battery is replaced
or recharged.
1. |
When replacing the battery, it should be
same one (type, capacity and brand) that is originally installed
on your vehicle. If a battery of a different type is replaced,
the battery sensor may recognize the battery to be abnormal. |
2. |
When installing the ground cable on the negative
post of battery, tighten the clamp with specified torque of
4.0~6.0N.m (0.4~0.6kgf.m, 3.0~4.4lb-ft). An excessive tightening
torque can damage the PCB internal circuit and the battery terminal. |
3. |
When recharging the battery, ground the negative
terminal of the booster battery to the vehicle body. If the
negative cable from a battery charger is connected to the negative
terminal of the battery, the battery sensor can make an error.
In this case, repeat the above process for battery sensor replacement
(1~3) after disconnecting and reconnecting the battery connector. |
|
1.
Make sure the ignition switch and all accessories
are in the OFF position.
2.
Disconnect the battery cables (negative first).
3.
...
See also:
Air conditioning
Press the A/C button to turn the air conditioning system on (indicator light
will illuminate).
Press the button again to turn the air conditioning system off. ...
Dome Light Bulb Replacement
WARNING
Prior to working on the Dome Light, ensure that the “OFF” button is depressed
to avoid burning your fingers or receiving an electric shock.
1. Using a flat-blade screwdriver, gently ...
Seat Belt Buckle Switch (BS). Description and Operation
Description
The SRSCM shall monitor the status of the driver and front passenger seat belt buckle.
The SRSCM provides one pin each for the driver and front passenger seat belt buckle
status input ...