Kia Optima: Automatic Transaxle Control System
- Description and Operation
- Repair procedures
- Schematic Diagrams
- Components and Components Location
- Transaxle Control Module (TCM). Description and Operation
- Transaxle Control Module (TCM). Schematic Diagrams
- Transaxle Control Module (TCM). Repair procedures
- Transaxle Oil Temperature Sensor. Description and Operation
- Transaxle Oil Temperature Sensor. Specifications
- Transaxle Oil Temperature Sensor. Schematic Diagrams
- Transaxle Oil Temperature Sensor. Repair procedures
- Input Speed Sensor. Description and Operation
- Input Speed Sensor. Specifications
- Input Speed Sensor. Schematic Diagrams
- Input Speed Sensor. Troubleshooting
- Input Speed Sensor. Repair procedures
- Output Speed Sensor. Description and Operation
- Output Speed Sensor. Specifications
- Output Speed Sensor. Schematic Diagrams
- Output Speed Sensor. Troubleshooting
- Output Speed Sensor. Repair procedures
- Torque Converter Control Solenoid Valve (T/CON_VFS). Description and Operation
- Torque Converter Control Solenoid Valve (T/CON_VFS). Specifications
- Torque Converter Control Solenoid Valve (T/CON_VFS). Schematic Diagrams
- Torque Converter Control Solenoid Valve (T/CON_VFS). Repair procedures
- 26 Brake Control Solenoid Valve(26/B_VFS). Description and Operation
- 26 Brake Control Solenoid Valve(26/B_VFS). Specifications
- 26 Brake Control Solenoid Valve(26/B_VFS). Schematic Diagrams
- 26 Brake Control Solenoid Valve(26/B_VFS). Repair procedures
- Line Pressure Control Solenoid Vale. Description and Operation
- Line Pressure Control Solenoid Vale. Specifications
- Line Pressure Control Solenoid Vale. Schematic Diagrams
- Line Pressure Control Solenoid Vale. Repair procedures
Flow Diagram
Power Flow Chart
P,N
UD/B
LR/B
26/B
35R/C
OD/C
OWC
●
...
See also:
Lift And Support Points
When heavy rear components such as suspension, fuel tank, spare tire,
tailgate and trunk lid are to be removed, place additional weig ...
Removal
1.
Turn the ignition switch OFF and disconnect the battery
negative (-) cable.
2.
Disconnect the connector (A), and then remove the
sensor (B).
...
When to replace seat belts
The entire in-use seat belt assembly or assemblies should be replaced if the
vehicle has been involved in an accident. This should be done even if no damage
is visible. Additional questions concer ...
Copyright © www.kiopman.com 2024