Kia Optima: Air Intake Control Switch - Manual Climate Control System - Driving Your Vehicle - Kia Optima MS/Magentis 2000-2005 Owners ManualKia Optima: Air Intake Control Switch

This is used to select fresh outside air or recirculation of the inside air.

WARNING WARNING

Recirculated Air Position

control switch is depressed (switch indicator illuminates), almost all outside airWhen the air intake control switch is depressed (switch indicator illuminates), almost all outside air flow into the vehicle is shut off and air inside the vehicle is recirculated.

This position can be used temporarily for maximum heating or cooling (if equipped with air conditioning) and to help prevent undesirable outside air flow into the vehicle.

Outside (Fresh) Air Position

outside (fresh) air position by pressing the air intake control switch, air entersWhen you select the outside (fresh) air position by pressing the air intake control switch, air enters the ventilation system from outside the vehicle. Use this position for normal ventilation and heating.

The air flow control will be set at outside (fresh) air position automatically if any of following occur.

- The ignition key is OFF.
- The fan speed control knob is OFF (0).
- When you select the floor, floor-defrost or defrost mode position.

If you want the recirculated air position, press the corresponding button.

To cancel the forced outside (fresh) air position, refer to the canceling procedure in “Windshield Defrosting and Defogging” section.

Temperature Control Knob
The temperature control knob is the round knob closest to the passenger side of the ventilation control panel. To change the air temperature in the passenger compartment, turn the knob either cloc ...

Air Conditioning Switch
Press the switch to turn the air conditioning system on. An indicator light in the switch will illuminate when the fan switch is on indicating air conditioning system operation. Press the switch ...

See also:

Checking the brake/clutch* fluid level
Check the fluid level in the reservoir periodically. The fluid level should be between MAX and MIN marks on the side of the reservoir. Before removing the reservoir cap and adding brake/c ...

Heated Oxygen Sensor (HO2S). Schematic Diagrams
Circuit Diagram ...

Automatic Transaxle Operation
The optional automatic transaxle is electronically controlled. All normal forward driving is done with the shift lever in the D (Drive) position. To move the shift lever from the P (Park) position ...

Copyright © www.kiopman.com 2024