Kia Optima: Water pump Repair procedures - Cooling System - Engine Mechanical SystemKia Optima: Water pump Repair procedures

Removal and Installation
1.
Loosen the drain plug, and then drain the engine coolant. Remove the radiator cap to help drain the coolant faster.
2.
Remove the water pump drive belt (A).

(1)


(1)
Put the SST (09252-3D100) between the crankshaft pulley and the drive belt.
(2)
Rotate the crankshaft pulley clockwise. Then the drive belt is removed.

When installing the water pump drive belt,


When installing the water pump drive belt,
(1)
Put the SST (09252-03200) between the crankshaft pulley and the drive belt.
(2)
Rotate the crankshaft pulley clockwise. Then the drive belt is installed.


3.
Remove the water pump pulley (A) and the dust cover (B).

Tightening torque :
7.8 ~ 9.8N.m (0.8 ~ 1.0kgf.m, 5.8~ 7.2lb-ft)


4.
Remove the water pump (A) with the gasket.

Tightening torque :
18.6 ~ 23.5N.m (1.9 ~ 2.4kgf.m, 13.7 ~ 17.4lb-ft)


5.
Remove the exhaust manifold heat protector. (Refer to Intake and exhaust system)
6.
Remove the water pump cover (B) with the gasket and the water inlet pipe (A).

Tightening torque :
18.6 ~ 23.5N.m (1.9 ~ 2.4kgf.m, 13.7 ~ 17.4lb-ft)


7.
Installation is reverse order of removal with a new water pump gasket.
8.
Fill the engine coolant.
9.
Start the engine and check for leaks.
10.
Recheck the coolant level.
Inspection
1.
Check each part for cracks, damage or wear, and replace the coolant pump assembly if necessary.
2.
Check the bearing for damage, abnormal noise and sluggish rotation, and replace the coolant pump assembly if necessary.
3.
Check for coolant leakage. If coolant leaks from hole, the seal is defective. Replace the coolant pump assembly.
   
   
A small amount of "weeping" from the bleed hole is normal.
Water pump Components and Components Location
Components 1. Water pump pulley2. Dust cover3. Water pump sub assembly (Water pump housing)4. Water pump housing gasket5. Water pump cover6. Water pump gasket7. Water inlet pipe gasket (O-ring)8. ...

Water pump Troubleshooting
Troubleshooting SymptomsPossible CausesRemedyCoolant leakage • From the bleed hole of the water pump Visually check • Check leaks after about ten-minute warming up. • ...

See also:

Replacement
Standard values, such as torques and certain adjustments, must be strictly observed in the reassembly of all parts.If removed, the following parts should always be replaced with new ones. ...

Repair procedures
Diagnosis With GDS 1. BSD system defects can be quickly diagnosed with the GDS. GDS operates actuator quickly to monitor, input/output value and self diagnosis. 2. Connect the cable of GDS ...

Inspection
1. Connect the battery voltage and check the blower motor rotation. 2. If the blower motor voltage is not operated well, substitute with a known-good blower m ...

Copyright www.kiopman.com 2020