Kia Optima: Water pump Components and Components Location - Cooling System - Engine Mechanical SystemKia Optima: Water pump Components and Components Location

Components


1. Water pump pulley
2. Dust cover
3. Water pump sub assembly
(Water pump housing)
4. Water pump housing gasket
5. Water pump cover
6. Water pump gasket
7. Water inlet pipe gasket (O-ring)
8. Water inlet pipe
9. Water temperature control assembly
10. Water temperature control assembly
gasket A
11. Water temperature control assembly
gasket B
12. Water inlet fitting
13. Engine coolant temperature sensor
14. Thermostat
15. Thermostat gasket
16. Throttle body coolant hose

Radiator Repair procedures
Inspection Radiator Cap Testing 1. Remove the radiator cap, wet its seal with engine coolant, and then install it on a pressure tester. 2. Apply a pressure of 93.16 ~ 122.58kPa (0.95 ~ 1.25kg ...

Water pump Repair procedures
Removal and Installation 1. Loosen the drain plug, and then drain the engine coolant. Remove the radiator cap to help drain the coolant faster. 2. Remove the water pump drive belt (A). (1) P ...

See also:

Components and Components Location
Components 1. Front seat belt 2. Height adjuster 3. Rear seat belt [RH] 4. Rear center seat belt 5. Rear seat belt [LH] 6. Rear seat belt buckle ...

Balance Shaft & Oil Pump Repair procedures
Removal Balance Shaft Module (BSM) Chain System 1. Remove the timing chain. (Refer to Timing system in this group) 2. Install a stopper pin (A) after compressing the balance shaft chain tensi ...

Climate control air filter
Filter inspection The climate control air filter should be replaced according to the Maintenance Schedule. If the vehicle is operated in severely air-polluted cities or on dusty rough roads f ...

Copyright © www.kiopman.com 2020