Kia Optima: Troubleshooting
| Troubleshooting |
| 1. |
The lamp switch inputs can be checked using the GDS. |
| 2. |
To check the input value of lamp switch, select option "Body Control Module". |
| 3. |
To consult the present input/output value of BCM, "Current
DATA". It provides information of BCM input/output conditions of power
supply, turn signal/brake lamp, headlamp, door, locks, outside mirror,
wiper, auto-light and transmitters etc.
|
| 4. |
To check the input value of lamp switch in force mode, select option "Actuation Test".
|
| Symptom | Possible cause | Remedy |
| One lamp does not light (all exterior) | Bulb burned out | Replace bulb |
| Socket, wiring or ground faulty | Repair if necessary | |
| Stop lamps do not light | Bulb burned out | Replace bulb |
| Stop lamp fuse (15A) blown | Check for short and replace fuse | |
| Stop lamp switch faulty | Adjust or replace switch | |
| Wiring or ground faulty | Repair if necessary | |
| Stop lamps do not turn off | Stop lamp switch faulty | Repair or replace switch |
| Instrument lamps do not light (Tail lamps light) | Rheostat faulty | Check rheostat |
| Wiring or ground faulty | Repair if necessary | |
| Back up lamps do not light | Bulb burned out | Replace bulb |
| Back up lamp fuse (10A) blown | Check for short and replace fuse | |
| Back up lamp switch (M/T) faulty | Check switch | |
| Transaxle range switch (A/T) faulty | Check switch | |
| Wiring or ground faulty | Repair if necessary | |
| Map lamp does not light | Bulb burned out | Replace bulb |
| Room lamp fuse (10A) blown | Check for short and replace fuse | |
| Map lamp switch faulty | Check switch | |
| Wiring or ground faulty | Repair if necessary | |
| Luggage room lamp does not light | Bulb burned out | Replace bulb |
| Trunk lamp fuse (10A) blown | Check for short and replace fuse | |
| Luggage room lamp switch faulty | Check switch | |
| Wiring or ground faulty | Repair if necessary |
Turn Signal Lamp Repair procedures
Removal
Door Mirror Turn Signal Lamp
1.
Disconnect the negative (-) battery terminal.
2.
Remove the mirror (C) after disconnecting the heater connector (A) and BSD warning connector (B).
3 ...
See also:
Tire Size Designation
A tire’s sidewall is marked with a tire size designation. You will need this
information when selecting replacement tires for your car. The following explains
what the letters and numbers in the t ...
Balance Shaft & Oil Pump Components and Components Location
Components
1. Balance shaft & oil pump assembly2. Balance shaft chain tensioner3. Balance shaft chain4. Balance shaft chain sprocket5. Balance shaft chain guide6. Balance shaft chain tensione ...
Front Body A
Hood hinge mounting hole (Ø10)
Fender apron upper inner panel tooling hole (Ø6.6)
Front sus ...
Copyright © www.kiopman.com 2021