Kia Optima: Special Service Tools - Steering SystemKia Optima: Special Service Tools

Special Service Tools
Tool Name / Number
IIIustration
Description
Lower arm ball joint remover
0K545-A9100

Personal Protective Equipment

Removal of front lower arm from front axle


Personal Protective Equipment
Name
Illustration
Description
Insulation glove

the high voltage components with insulation sheet to prevent people who

Used when inspecting or working on the high voltage components
[Insulation performance : 1000V / 300A or above]
Insulation shoes

the high voltage components with insulation sheet to prevent people who

Used when inspecting or working on the high voltage components
Insulation clothes

the high voltage components with insulation sheet to prevent people who

Insulation helmet

the high voltage components with insulation sheet to prevent people who

Safety glasses

the high voltage components with insulation sheet to prevent people who

Used in the case below
• During Removal & installation or inspection of the high voltage battery terminals or wiring, which spark might happen.
• During working on the high voltage battery pack assembly.
Face shield

the high voltage components with insulation sheet to prevent people who

Insulation mat

the high voltage components with insulation sheet to prevent people who

Putting the removed high voltage components on the insulation mat to prevent safety accidents.
Insulation sheet

the high voltage components with insulation sheet to prevent people who

Covering
the high voltage components with insulation sheet to prevent people who don’t wear the personal protective equipment from safety accidents.


Specifications
Specifications ItemSpecificationTypeMotor Driven Power SteeringSteering gearTypeRack & PinionRack stroke148mm (5.82in)Steering angle(Max.)Inner40.05° ± 1.5°Outer32.95° Tightening Torqu ...

Troubleshooting
Troubleshooting SymptomProbable causeRemedyPlay in steeringLoose yoke plugRetightenLoose steering gear mounting boltsRetightenLoose or worn tie rod endRetighten or replace as necessarySteering w ...

See also:

Inspection
1. Turn the ignition switch OFF. 2. Disconnect the injector connector. 3. Measure resistance between the injector terminals 1 and 2. ...

Removal
1. Remove the head lamp leveling unit connector (A). 2. Loosen the mounting bolts (3EA) of automatic head lamp leveling unit assembly. Tighting torq ...

Mode Control Actuator. Description and Operation
Description The mode control actuator is located at the heater unit.It adjusts position of mode door by operating mode control actuator based on signal of A/C control unit. Pressing mode select s ...

Copyright www.kiopman.com 2021