Kia Optima: Side Impact Sensor (SIS) Description and Operation - SRSCM - RestraintKia Optima: Side Impact Sensor (SIS) Description and Operation

Description
Side Impact Sensor (SIS) system consists of two P-SIS which are installed at each center of the front door module (LH and RH) and two SIS which are installed at each center pillar nearby (LH and RH).
Side Pressure Sensor is also called P-SIS because it detects pressure due to collision at its mounting location.
Side Impact Sensor is also called A-SIS because it detects acceleration.
SRSCM decides deployment of the airbag and the time of deployment through the collision signal of the SIS when the collision occurred.
Front Impact Sensor (FIS) Repair procedures
Removal     • Removal of the airbag must be performed according to the precautions/ procedures described previously. • Before disconnecting the front i ...

Side Impact Sensor (SIS) Components and Components Location
Components ...

See also:

Schematic Diagrams
System Block Diagram Component Parts And Function Outline Component part Function Vehicle speed sensor Converts vehicle speed to pulse. ...

Front Washer Motor Repair procedures
Inspection 1. With the washer motor connected to the reservoir tank, fill the reservoir tank with water.     Before filling the reservoir tank with water, check the fil ...

Wheel Repair procedures
Hub nut tightening sequence Tighten the hub nuts as follows. Tightening torque: 88.3 ~ 107.9N.m (9.0 ~ 11.0kgf.m, 65.1 ~ 79.6lb-ft)     When using an impact gun, fin ...

Copyright www.kiopman.com 2021