Kia Optima: Seat Track Position Sensor (STPS) Repair procedures - SRSCM - RestraintKia Optima: Seat Track Position Sensor (STPS) Repair procedures

Removal
1.
Disconnect the battery negative cable, and wait for at least three minutes before beginning work.
2.
Remove the front seat assembly. (Refer to BD group)
3.
Loosen the two STPS screws, then remove the STPS after disconnecting the STPS connector.

Installation


Installation
   
   
Be sure to install the harness wires not to be pinched or interfered with other parts.
1.
Remove the ignition key from the vehicle.
2.
Disconnect the battery negative cable, and wait for at least three minutes before beginning work.
3.
Install the STPS with two screws.
4.
Install the front seat assembly. (Refer to BD group)
5.
Reconnect the battery negative cable.
6.
After installing the Seat Track Position Sensor, confirm proper system operation:
Turn the ignition switch ON, the SRS indicator should be turned on for about six seconds and then go off.
Seat Track Position Sensor (STPS) Components and Components Location
Components ...

Seat Belt Buckle Switch (BS) Description and Operation
Description The SRSCM shall monitor the status of the driver and front passenger seat belt buckle. The SRSCM provides one pin each for the driver and front passenger seat belt buckle status inp ...

See also:

Placing a passenger seat belt into the auto lock mode
The auto lock mode will help prevent the normal movement of the child in the vehicle from causing the seat belt to loosen and compromise the child restraint system. To secure a child restraint s ...

Removal
1. Remove the timing chain. (Refer to Timing system in this group) 2. Install a stopper pin (A) after compressing the balance shaft chain tensioner. 3. ...

Schematic Diagrams
Circuit Diaram ...

Copyright © www.kiopman.com 2021