Kia Optima: Seat Track Position Sensor (STPS) Description and Operation
| Description |
The STPS operates via a non-contacting magnetic proximity
sensing device combined with a simple electronic circuit resulting in
the ability of producing two separate and distinct logic level signals.
The STPS output signal is altered by the proximity of a
separate ferro-magnetic shunt, which is linked via the seat track. The
logic signal produced is the result of the proximity device being
activated or deactivated.
When the seat is in the forward position zone of the track,
the sensor gives a low current (prohibit) signal. When the seat is in
the rear positon zone of the track, it gives a high current (enable)
signal.
Side Impact Sensor (SIS) Repair procedures
Removal
Pressure Side Impact Sensor
•
Removal of the airbag must be performed according to the precautions/procedures described previously.
•
Be ...
See also:
Removal
1.
Turn the ignition switch OFF and disconnect the battery
negative (-) cable.
2.
Release the residual pressure in fuel line (Refer
to “Release Residual Pre ...
Digital Clock
When the ignition switch is in the ACC or ON position, the clock buttons operate
as follows:
A digital clock will not be installed if your vehicle comes equipped with an
audio system. Vehicles ...
Front Body B
Hood hinge mounting hole (Ø10)
Fender apron upper inner panel tooling hole (Ø6.6)
Engine mo ...
Copyright © www.kiopman.com 2020