The front passenger's seat belt warning light will activate to the following table when the ignition switch is in "ON" position.
*1 The seat belt warning light will go off if the vehicle speed decreases below 5 km/h (3 mph). If the vehicle speed increases above 5 km/h (3 mph), the warning light will blink again.
✽ NOTICE
Fender Repair procedures
Replacement
•
Be careful not to damage the fender and body.
•
When removing the clips, use a clip remover.
1.
Remove the front bumper.
(Ref ...
26 Brake Control Solenoid Valve(26/B_VFS). Schematic Diagrams
Circuit Diagram
...
Removal
1.
Turn the ignition switch OFF and disconnect the battery
negative (-) cable.
2.
Disconnect the manifold absolute pressure sensor
connector (A).
...