Kia Optima: Seat Belt Pretensioner (BPT) Repair procedures - Seat Belt Pretensioner - RestraintKia Optima: Seat Belt Pretensioner (BPT) Repair procedures

Removal
1.
Disconnect the battery negative cable, and wait for at least three minutes before beginning work.
2.
To remove the seat belt anchor pretensioner (C), keep on pushing the lock pin (A) as arrow direction. And then remove the seat belt after pushing the lock pin (B).


3.
Remove the door scuff trim. (Refer to the Body group- Interior trim)
4.
Remove the center pillar trim. (Refer to the Body group- Interior trim)
5.
Remove the upper anchor bolt.
6.
Disconnect the seat belt pretensioner connector (A).


7.
Loosen the seat belt pretensioner mounting bolts (B, C) and remove the seat belt pretensioner.
Installation
1.
Remove the ignition key from the vehicle.
2.
Disconnect the battery negative cable and wait for at least three minutes.
3.
Install the seat belt pretensioner with bolts (B, C).

Tightening torque:
Bolt B: 39.2 ~ 53.9 N.m (4.0 ~ 5.5 kgf.m, 28.9 ~ 39.8 lb-ft)


4.
Connect the seat belt pretensioner connector (A).
5.
Install the upper anchor bolt.

Tightening torque:
39.2 ~ 53.9 N.m (4.0 ~ 5.5 kgf.m, 28.9 ~ 39.8 lb-ft)

6.
Install the center pillar trim. (Refer to the Body group- Interior trim)
7.
Install the door scuff trim. (Refer to the Body group- Interior trim)
8.
Insert the seat belt to the anchor pretensioner.
   
   
Make sure the lock pin is connected in properly.
9.
Reconnect the battery negative cable.
10.
After installing the seat belt pretensioner, confirm proper system operation:
•
Turn the ignition switch ON; the SRS indicator light should be turned on for about six seconds and then go off.
Seat Belt Pretensioner (BPT) Components and Components Location
Components ...

Anchor Pretensioner (APT) Description and Operation
Description Front seat belt anchor pretensioner operates as well as belt pretensioner at the same time If it gets into its deploy condition after a collision. It is located at near anchor on fr ...

See also:

Intake Actuator Repair procedures
Inspection 1. Ignition "OFF". 2. Disconnect the intake actuator connector. 3. Verify that the actuator operates to the recirculation position when connecting 12V to the terminal 3 and grou ...

When Your Vehicle Is Being Towed By Another Vehicle Other Than a Tow Truck (in case of an emergency)
Turn the ignition switch to ACC so the steering wheel isn’t locked. Place the transaxle shift lever in N (Neutral). Vehicles equipped with automatic transaxles should not exceed 28 mph and s ...

Outside Rearview Mirrors Electric Remote Control
The electric remote control mirror switch, located on the left side of the instrument panel on the drivers door, allows you to adjust the position of the left and right outside rearview mirrors. ...

Copyright © www.kiopman.com 2021