Kia Optima: Seat Belt Buckle Switch (BS) Repair procedures - SRSCM - RestraintKia Optima: Seat Belt Buckle Switch (BS) Repair procedures

Removal
1.
Disconnect the battery negative cable, and wait for at least three minutes before beginning work.
2.
Remove the front seat assembly.
(Refer to the Body group- Front seat)
3.
Loosen the seat belt buckle mounting bolt and remove the seat belt buckle switch.

Installation


Installation
   
   
Be sure to install the harness wires so they will not pinch or interfere with other parts.
1.
Remove the ignition key from the vehicle.
2.
Disconnect the battery negative cable, and wait for at least three minutes before beginning work.
3.
Install the seat belt buckle switch.

Tightening torque:
39.2 ~ 53.9 N.m (4.0 ~ 5.5 kgf.m, 28.9 ~ 39.8 lb-ft)

4.
Install the front seat assembly.
(Refer to the Body group- Front seat)
5.
Reconnect the battery negative cable.
6.
After installing the seat belt buckle switch, confirm proper system operation:
•
Turn the ignition switch ON; the SRS indicator should be turned on for about six seconds and then go off.
Seat Belt Buckle Switch (BS) Components and Components Location
Components ...

Weight Classification System (WCS) Description and Operation
Description In contrast to the initial one-stage airbag systems, newer restraint systems involve complex logic to select, or alternatively suppress, various levels of safety system deployment. ...

See also:

Audio Unit. Components and Components Location
Components ...

General Safety Information and Caution
Safety Precaution     Since hybrid vehicles contain a high voltage battery, if the high voltage system or vehicles are handled incorrectly, this might lead to a ser ...

Tire terminology and definitions
Air Pressure: The amount of air inside the tire pressing outward on the tire. Air pressure is expressed in pounds per square inch (psi) or kilopascal (kPa). Accessory Weight: This means the ...

Copyright © www.kiopman.com 2021