Kia Optima: Schematic Diagrams
| Circuit Diagram (1) |
| Circuit Diagram (2) |
| Circuit Diagram (3) |
| SRSCM Connector Terminal |
| Pin | Function (Connector A) | Pin | Function (Connector B) | ||
| 1 | P | Smart Junction Box (Fuse - A/BAG) | 1 | O | Passenger Side Impact Sensor (High) |
| 2 | - | - | 2 | L | Passenger Side Impact Sensor (Low) |
| 3 | - | - | 3 | G | Driver Side Impact Sensor (High) |
| 4 | G/O | Driver Front Impact Sensor (High) | 4 | B/O | Driver Side Impact Sensor (Low) |
| 5 | L | Driver Front Impact Sensor (Low) | 5 | L | Passenger Pressure Side Impact Sensor (High) |
| 6 | G | Passenger Front Impact Sensor(High) | 6 | O | Passenger Pressure Side Impact Sensor (Low) |
| 7 | L | Passenger Front Impact Sensor(Low) | 7 | L | Driver Pressure Side Impact Sensor(High) |
| 8 | Y | C-CAN (Low) | 8 | Y | Driver Pressure Side Impact Sensor (Low) |
| 9 | W | C-CAN (High) | 9 | B | Ground (GF05) |
| 10 | - | - | 10 | - | - |
| 11 | - | - | 11 | - | - |
| 12 | Y/O | Driver Air Bag (1st Stage - High) | 12 | P | Driver Seat Belt Buckle Switch (High) |
| 13 | L/B | Driver Air Bag (1st Stage - Low) | 13 | G/B | Driver Seat Belt Buckle Switch (Low) |
| 14 | Br/O | Passenger Air Bag (1st Stage - Low) | 14 | L/O | Driver Seat Belt Pretensioner (High) |
| 15 | Br | Passenger Air Bag(1st Stage - High) | 15 | Br | Driver Seat Belt Pretensioner (Low) |
| 16 | - | - | 16 | R | Passenger Seat Belt Pretensioner(Low) |
| 17 | - | - | 17 | B | Passenger Seat Belt Pretensioner(High) |
| 18 | - | - | 18 | B | Driver Curtain Air Bag (High) |
| 19 | - | - | 19 | R | Driver Curtain Air Bag (Low) |
| 20 | - | - | 20 | - | - |
| 21 | Br | Smart Junction Box(IPS Control Module) | 21 | - | - |
| 22 | O | Crash Signal Output : MTS Module, BCM, A/V &Navigation Head Unit | 22 | - | - |
| 23 | Br/O | Driver Air Bag (2nd Stage - Low) | 23 | - | - |
| 24 | Gr/O | Driver Air Bag (2nd Stage - High) | 24 | - | - |
| 25 | B | Passenger Air Bag(2nd Stage - High) | 25 | Y/B | Passenger Seat Belt Buckle Switch (High) |
| 26 | R | Passenger Air Bag(2nd Stage - Low) | 26 | W | Passenger Seat Belt Buckle Switch (Low) |
| 27 | L | Telltale Lamp (-) | 27 | P/B | Driver Side Air Bag (High) |
| 28 | O/B | Driver Side Air Bag (Low) | |||
| 29 | Gr | Passenger Side Air Bag (Low) | |||
| 30 | W/B | Passenger Side Air Bag (High) | |||
| 31 | G | Passenger Curtain Air Bag (High) | |||
| 32 | W | Passenger Curtain Air Bag (Low) | |||
| 33 | Y | Driver Anchor Pretensioner (Low) | |||
| 34 | Gr | Driver Anchor Pretensioner (High) | |||
| 35 | L | Passenger Anchor Pretensioner(High) | |||
| 36 | W | Passenger Anchor Pretensioner(Low) | |||
| 37 | - | - | |||
| 38 | G | Driver Seat Track Position Sensor(High) | |||
| 39 | B | Driver Seat Track Position Sensor(Low) | |||
Weight Classification System (WCS) Repair procedures
Removal
1.
Disconnect the battery negative cable, and wait for at least three minutes before beginning work.
2.
Remove the front passenger seat assembly.
(Refer to the Body group - "Seat")
...
Airbag Module
...
See also:
Inspection
1.
Check the signal waveform of the CMPS and CKPS using
the GDS.
Specification:
Refer to “Wave Form”
...
Front Driveshaft Components and Components Location
Component location
1. Driveshaft (LH) 2. Driveshaft (RH)
Components
1. BJ assembly2. Circlip3. BJ boot band4. BJ boot5. Dynamic damper band6. Dynamic damper7. Shaft8. TJ boot band9. TJ boo ...
Removal
1.
Release the residual pressure in fuel line (Refer
to “Release Residual Pressure in Fuel Line” in this group).
2.
Remove the fuel pump service cover (A) in the ...
Copyright © www.kiopman.com 2020