Kia Optima: Repair procedures - Electro chromic Inside Rear View Mirror - Body Electrical SystemKia Optima: Repair procedures

Inspection
Check it by the procedure below to see if the function of the ECM is normal.
1.
Turn the ignition key to the "ON" position.
2.
Cover the front sensor to stop functioning.
3.
Shine a light at the rear sensor.
4.
The ECM should be darkened as soon as the rear sensor detects the light.
   
   
If this test is performed in daytime, the ECM may be darkened as soon as the front sensor is covered.
5.
When the reverse gear is engaged, the ECM should not be darkened.
6.
When heading lights to both the front and rear sensors, the ECM should not be darkened.
Removal
1.
Remove the mirror wiring cover (A).


2.
Disconnect the mirror connector (B) and remove the mounting screw (A).


3.
Slide the inside rear view mirror rearward to remove the inside rear view mirror assembly (A).


   
   
Take care not to damage the mounting bracket during removal.
Installation
1.
Install the mirror assembly.
2.
Install the mirror wiring cover and connector.
   
   
–
Make sure the connector is plugged in properly.
Description and Operation
Description The ECM (Electro Chromatic inside rear view Mirror) is for dimming the reflecting light from a vehicle behind at night, Preventing glare from the light. The forward facing sensor de ...

Compass Mirror Description and Operation
Function 1. Push the A button lower of the rear view mirror to turn on the function of the compass mirror so that displays a sign of a direction on the small board in the upper-right side of t ...

See also:

Components and Components Location
Components 1. Driver Airbag (DAB)2. Steering Wheel3. Clock Spring4. Seat Belt Pretensioner (BPT)5. Pressure Side Impact Sensor (P-SIS)6. Side Impact Sensor (SIS)7. Side Airbag (SAB)8. Passenger A ...

Driver Airbag (DAB) Module and Clock Spring. Components and Components Location
Components 1. Driver Airbag (DAB) 2. Steering Wheel 3. Clock Spring ...

Exhaust Manifold. Repair procedures
Removal and Installation 1. Remove the engine cover. 2. Disconnect the battery negative terminal. Tightening torque4.0 ~ 6.0N.m (0.4 ~ 0.6kgf.m, 3.0 ~ ...

Copyright © www.kiopman.com 2020