Kia Optima: Rear Cross Member Repair procedures - Rear Suspension System - Suspension SystemKia Optima: Rear Cross Member Repair procedures

Replacement
1.
Remove the rear wheel & tire.

Tightening torque:
88.3 ~ 107.9N.m(9.0 ~ 11.0kgf.m, 65.1 ~ 79.6lb-ft)


   
   
Be careful not to damage the hub bolts when removing the rear wheel & tire.
2.
Remove the rear lower arm.
(Refer to lower arm)
3.
Remove the rear shock absorber.
(Refer to rear shock absorber)
4.
Remove the rear upper arm.
(Refer to rear upper arm)
5.
Remove the trailing arm.
(Refer to trailing arm)
6.
Remove the rear assist arm.
(Refer to rear assist arm)
7.
Remove the rear muffler.


8.
Loosen the mounting bolts and then remove the rear cross member (A) from the frame.

Tightening torque:
156.9 ~ 176.5N.m(16.0 ~ 18.0kgf.m, 115.7~130.2lb-ft)


9.
Installation is the reverse of removal.
Trailing Arm Repair procedures
Replacement 1. Remove the rear wheel & tire. Tightening torque: 88.3 ~ 107.9N.m (9.0 ~ 11.0kgf.m, 65.1 ~ 79.6lb-ft)     Be careful not to damage the hub bolts w ...

Tires/Wheels
...

See also:

Underdrive Brake Control Solenoid Valve (UD/B_VFS) Schematic Diagrams
Circuit Diagram ...

Recommended SAE viscosity number
CAUTION Always be sure to clean the area around any filler plug, drain plug, or dipstick before checking or draining any lubricant. This is especially important in dusty or sandy areas and ...

Circuit Diagram (2)
...

Copyright © www.kiopman.com 2021