Kia Optima: Rear Assist Arm Repair procedures - Rear Suspension System - Suspension SystemKia Optima: Rear Assist Arm Repair procedures

Replacement
1.
Remove the rear wheel & tire.

Tightening torque:
88.3 ~ 107.9 N.m(9.0 ~ 11.0kgf.m, 65.1 ~ 79.6lb-ft)


   
   
Be careful not to damage the hub bolts when removing the rear wheel & tire.
2.
Remove the sprit pin and castle nut and then disconnect the rear assist arm (A) from the rear axle.

Tightening torque:
78.4 ~ 88.3N.m(8.0 ~ 9.0kgf.m, 57.8 ~ 65.1lb-ft)


3.
Loosen the bolt & nut and then remove the rear assist arm (A) from the sub frame.

Tightening torque:
107.9 ~ 117.7N.m(11.0 ~ 12.0kgf.m, 79.6 ~ 86.8lb-ft)


4.
Installation is the reverse of removal.
Inspection
1.
Check the bushing for wear and deterioration.
2.
Check for all bolts and nut.
Rear Stabilizer Bar Repair procedures
Replacement 1. Remove the rear wheel & tire. Tightening torque: 88.3 ~ 107.9N.m (9.0 ~ 11.0kgf.m, 65.1 ~ 79.6lb-ft)     Be careful not to damage the hub bolts w ...

Trailing Arm Repair procedures
Replacement 1. Remove the rear wheel & tire. Tightening torque: 88.3 ~ 107.9N.m (9.0 ~ 11.0kgf.m, 65.1 ~ 79.6lb-ft)     Be careful not to damage the hub bolts w ...

See also:

IMS Power Seat Control Schematic Diagrams
Circuit diagram ...

TCM Terminal Input/ Output Signal
Connector [CHTG-AG] Pin Description Condition Input/output value Type Level 1 -   ...

Seat Track Position Sensor (STPS) Description and Operation
Description The STPS operates via a non-contacting magnetic proximity sensing device combined with a simple electronic circuit resulting in the ability of producing two separate and distinct lo ...

Copyright © www.kiopman.com 2021