Kia Optima: Purge Control Solenoid Valve (PCSV) Repair procedures - Engine Control System - Engine Control/Fuel SystemKia Optima: Purge Control Solenoid Valve (PCSV) Repair procedures

Inspection
1.
Turn the ignition switch OFF.
2.
Disconnect the PCSV connector.
3.
Measure resistance between the PCSV terminals 1 and 2.
4.
Check that the resistance is within the specification.

Specification: 19.0 ~ 22.0? [20°C(68°F)]

Removal
1.
Turn the ignition switch OFF and disconnect the battery negative (-) terminal.
2.
Disconnect the purge control solenoid valve connector (A).
3.
Disconnect the vapor hoses (B) from the purge control solenoid valve.


4.
Remove the valve from the bracket in the direction of the arrow.

Installation


Installation
   
   
Install the component with the specified torques.
Note that internal damage may occur when the component is dropped. If the component has been dropped, inspect before installing.
Use care to keep foreign material out of the valve.
Install the purge control solenoid valve after lifting the support pin (A) of the bracket.
1.
Install in the reverse order of removal.

Purge control solenoid valve bracket mounting bolt: 9.8 ~ 11.8 N.m (1.0 ~ 1.2 kgf.m, 7.2 ~ 8.7 lb-ft)

Purge Control Solenoid Valve (PCSV) Schematic Diagrams
Circuit Diagram ...

CVVT Oil Control Valve (OCV) Description and Operation
Description Continuous Variable Valve Timing (CVVT) system advances or retards the valve timing of the intake and exhaust valve in accordance with the ECM control signal which is calculated by ...

See also:

Cowl Top Cover Repair procedures
Replacement 1. Remove the cap (B) and remove the nuts, then remove the wiper arm (A). Tightening torque : 22.6~26.5 N.m(2.3~2.7 kgf.m, 16.6~19.5 lb-ft) 2. Disconnect the nozzle hose (B). ...

Curtain air bag
Curtain air bags are located along both sides of the roof rails above the center pillar. They are designed to help protect the heads of the front seat occupants and the rear outboard seat occ ...

Repair procedures
General Inspection After or before servicing the EPS system, perform the troubleshooting and test procedure as follows. Compare the system condition with normal condition in the table below and i ...

Copyright www.kiopman.com 2020