Kia Optima: Power Door Lock Switch Repair procedures - Power Door Locks - Body Electrical SystemKia Optima: Power Door Lock Switch Repair procedures

Inspection
Driver Door Lock Switch Inspection
1.
Disconnect the negative (-) battery terminal.
2.
Remove the front door trim panel.
(Refer to the BD group - "Front door")
3.
Disconnect the connector from the power window switch module.


4.
Check for continuity between the terminals in each switch position according to the table.

Removal


Removal
1.
Disconnect the negative(-) battery terminal.
2.
Remove the front door trim panel.
(Refer to the BD group - "Front door")
3.
Remove the power window switch module (A) from the door trim after loosening the mounting screws (3EA).


   
   
Be careful not to damage door trim panel and door module mounting hooks.
Installation
1.
Install the power window switch module.
2.
Install the door trim panel after reconnecting the relevant connectors
   
   
Make sure that the power window switch module connectors are plugged properly.
Check that the power window switch and door lock switch operate normally.
Power Door Lock Relay Repair procedures
Inspection Diagnosis With GDS 1. It will be able to diagnose defects of power door lock with GDS quickly. GDS can operates actuator forcefully, input/output value monitoring and self diagnosi ...

Power Door Mirrors
...

See also:

Inspection
1. Turn ignition switch OFF. 2. Disconnect the oil temperature sensor connector. 3. Measure resistance between sensor signal terminal and sensor g ...

Windshield wiper/washer
A : Wiper speed control MIST Single wipe OFF Off INT Intermittent wipe AUTO Auto control wipe (if equipped) LO Low wiper speed HI High wiper speed B : Intermittent or Auto ...

Storing positions into memory using the buttons on the door
Storing drivers seat positions 1. Shift the shift lever into P while the ignition switch is ON. 2. Adjust the driver seat to position comfortable for the driver. 3. Press SET button on the contr ...

Copyright www.kiopman.com 2020