Kia Optima: Overdrive Clutch Control Solenoid Valve (OD/C_VFS) Repair procedures - Automatic Transaxle Control System - Automatic Transaxle SystemKia Optima: Overdrive Clutch Control Solenoid Valve (OD/C_VFS) Repair procedures

Inspection
1.
Turn ignition switch OFF.
2.
Remove the air duct (A).

Tightening torque:
7.8 ~ 9.8 N.m (0.8 ~ 1.0 kgf.m, 5.8 ~ 7.2 lb-ft)


3.
Remove the air cleaner assembly.
(1)
Disconnect the breather hose (A).
(2)
Disconnect the air intake hose (B) and then remove the air cleaner assembly (C).

Tightening torque:
Hose clamp bolt:
2.9 ~ 4.9 N.m (0.3 ~ 0.5 kgf.m, 2.2 ~ 3.6 lb-ft)
Air cleaner assembly bolts:
7.8 ~ 9.8 N.m (0.8 ~ 1.0 kgf.m, 5.8 ~ 7.2 lb-ft)


   
   
When installing the air intake hose, the plate of the hose clamp must be in line with the stopper of the hose.
When installing the air intake hose, the center of the mark of hose must be in line with the throttle body rib.


4.
Remove the solenoid valve connector (A).


5.
Measure resistance between signal terminal and ground terminal.
6.
Check that the resistance is within the specification.
Removal
   
   
Replacing an on/off solenoid valve (SS-A, SS-B) does not require additional hydraulic pressure adjustment; however, the hydraulic pressure will need to be adjusted after replacing the VFS solenoid valve. If replacing the VFS solenoid valve; also replace the valve body assembly.
(Refer to Hydraulic System - "Valve Body")
Overdrive Clutch Control Solenoid Valve (OD/C_VFS) Schematic Diagrams
Circuit Diagram ...

SS-A Solenoid Valve (ON/OFF) Description and Operation
Description The SS-A solenoid valve is attached to the valve body and is an SS-A solenoid valve that is used to change gears. ...

See also:

Removal
1. Remove the battery and the battery tray. (Refer to "Charging system" in EE group.) 2. Remove the under cover (A). Tightening torque:7.8 ~ 11 ...

Placement of a Child Restraint System
We recommend that, whenever possible, you put the child restraint in the center position of the rear seat and secure it to the vehicle with the lap belt. If the center rear seat is not available, o ...

Removal
1. Disconnect the negative (-) battery terminal. 2. Remove the driver airbag module. (Refer to the RT group) 3. Remove the steering wheel. (Refe ...

Copyright www.kiopman.com 2021