1. Raise and suitably support the vehicle.
2. Remove the drain plug located at the bottom center front of the transaxle pan.
3. After the oil has drained, completely install a new washer on the plug, reinstall
the drain plug, and tighten to 22 lb•ft (30 N•m).
4. Lower the vehicle.
5. Remove the Automatic Transaxle dipstick located near the center of the engine
compartment bulkhead and, using a funnel, add approximately 2 quarts (2 liters)
of automatic transaxle fluid (SK ATF SP-III or diamond ATF SP-III or equivalent).
✽ NOTICE
Do NOT overfill the automatic transaxle reservoir. Doing so can cause a seal “blow out,” loss of fluid, and damage to the transaxle. If you overfill the reservoir, you must drain the excess prior to driving the vehicle. The transaxle will hold 2.7 qts. (2.5L) when completely empty. However, it is likely that there will be fluid left in the transaxle after draining, especially if the front of the vehicle was raised to remove the drain plug.
6. Check the fluid level. If necessary, add a small amount of fluid and check
the level again. Continue this process until the level reads within “HOT” range.
7. Replace the dipstick and properly dispose of the used transaxle fluid.
Heated Oxygen Sensor (HO2S). Schematic Diagrams
Circuit Diagram
...
Manifold Absolute Pressure Sensor (MAPS). Specifications
Specification
Pressure
[kPa (kgf/cm², psi)]
Output Voltage (V)
20.0 (0.20, 2.9)
0.79
46.7 (0.47, 6.77)
1.84
...
Heated Steering wheel. Repair procedures
Inspection
Measure a temperature.
•
The temperature of wheel surface
grip must rise from -20°C to 20°C within 6 minute
•
The temperature of wheel surface
grip must ...