Removal |
1. |
Turn the ignition switch OFF and disconnect the battery negative (-) terminal. |
2. |
Disconnect the NVLD connector (A). |
3. |
Disconnect the ventilation hoses (B,C). |
4. |
Remove the NVLD after by loosening the bolts (A). |
Installation |
• |
Install the component with the specified torques. |
• |
Note that internal damage may occur when the component is dropped.
If the component has been dropped, inspect before installing.
|
1. |
Install in the reverse order of removal. |
NVLD mounting bolt:
2.3 ~ 3.3 N.m (0.2 ~ 0.3 kgf.m, 1.7 ~ 2.5 lb-ft) |
Inspection |
1. |
Turn ignition switch OFF. |
2. |
Disconnect the NVLD connector. |
3. |
Remove the NVLD. |
4. |
Connect the hose (A) to the canister hose connected port as below. |
5. |
After immersing the hose (A) in water, Apply more than 6 mbar (positive) pressure to Atmosphere port (B). |
6. |
If the NVLD is normal, many bubbles will indicate large leak.
|
1. |
Connect power supply line and ground line to the NVLD terminals as below. |
2. |
Measure current between the NVLD terminal 1 and battery (+) terminal during NVLD switch open. |
3. |
Measure current between the NVLD terminal 1 and battery (+) terminal during NVLD switch closed. |
4. |
Measure current between the NVLD terminal 2 and battery (+) terminal during NVLD switch open. |
5. |
Check the current is within the specification.
|
Troubleshooting
Troubleshooting
Fault Diagnosis
Features a fail-safe mechanism that prevents dangerous
situations from developing in the event of a transaxle failure. The limp
home mode engages if the trans ...
Blade replacement
When the wipers no longer clean adequately,
the blades may be worn or
cracked, and require replacement.
CAUTION
To prevent damage to the wiper
arms or other components, do not
attempt to mo ...
Specifications
Specification
Audio
ItemSpecificationModelRADIO/CD/MP3/SDARS (PA30AS)UVO2/ Bristiol audioInternal AmplifierPower supplyDC 14.4 V Negative groundOutput max power43W ? 4 : 14.4VLoad impedance (?)4 ...