Kia Optima: Manifold Absolute Pressure Sensor (MAPS) Repair procedures - Engine Control System - Engine Control/Fuel SystemKia Optima: Manifold Absolute Pressure Sensor (MAPS) Repair procedures

Inspection
1.
Connect the GDS on the Data Link Connector (DLC).
2.
Measure the output voltage of the MAPS at idle and IG ON.
Test Condition
Output Voltage (V)
IG ON
3.9 ~ 4.1
Idle
0.8 ~ 1.6

Removal
1.
Turn the ignition switch OFF and disconnect the battery negative (-) terminal.
2.
Disconnect the manifold absolute pressure sensor connector (A).
3.
Remove the mounting bolt (B), and then remove the sensor from the surge tank.

Installation


Installation
   
   
Install the component with the specified torques.
Note that internal damage may occur when the component is dropped. In this case, use it after inspecting.
Insert the sensor in the installation hole and be careful not to damage when installation.
1.
Install in the reverse order of removal.

Manifold absolute pressure sensor mounting bolt:
9.8 ~ 11.8 N.m (1.0 ~ 1.2 kgf.m, 7.2 ~ 8.7 lb-ft)

Manifold Absolute Pressure Sensor (MAPS) Schematic Diagrams
Circuit Diagram ...

Intake Air Temperature Sensor (IATS) Description and Operation
Description Intake Air Temperature Sensor (IATS) is included inside Manifold Absolute Pressure Sensor and detects the intake air temperature. To calculate precise air quantity, correction of t ...

See also:

Transaxle Oil Temperature Sensor Specifications
Specifications Type: Negative Thermal Coefficient Type Temp.(°C)°FResistance (k?)(-40)-4046.8(-20)-4.015.6(0)32.05.88(20)68.02.51(40)104.01.17(60)140.00.59(80)176.00.32(100)212.00.18(120)248.0 ...

Hood Repair procedures
Replacement Hood Assembly Replacement     • When removing and installing the hood, an assistant is necessary. • Be careful not to damage the hood and ...

Inspection
1. The rear glass defogger switch inputs can be checked using the GDS. 2. To check the input value of rear glass defogger switch, select option "Body Control Mod ...

Copyright www.kiopman.com 2020