Kia Optima: Fuel Tank Pressure Sensor (FTPS) Repair procedures - Engine Control System - Engine Control/Fuel SystemKia Optima: Fuel Tank Pressure Sensor (FTPS) Repair procedures

Inspection
1.
Connect the GDS on the Data Link Connector (DLC).
2.
Measure the output voltage of the FTPS.
Pressure [kPa (kgf/cm?, in H2O)
Output Voltage (V)
-6.67 (-0.068, -26.8)
0.5
0
2.5
+6.67 (0.068, 26.8)
4.5

Removal


Removal
1.
Turn the ignition switch OFF and disconnect the battery negative (-) terminal.
2.
Lift the vehicle.
3.
Remove the canister. (Refer to Emission Control System - "Canister")
4.
Support the fuel tank with a jack and then remove the right fuel tank band (A).


5.
Make a gap for removing the fuel tank pressure sensor by lowering the jack.
6.
Remove the fuel tank pressure sensor (A) by unfastening the hook.

Installation


Installation
   
   
Note that internal damage may occur when the component is dropped. In this case, use it after inspecting.
Insert the sensor in the installation hole and be careful not to damage when installation.
1.
Install in the reverse order of removal.
Fuel Tank Pressure Sensor (FTPS) Schematic Diagrams
Circuit Diagram ...

Injector Description and Operation
Description Based on information from various sensors, the ECM can calculate the fuel amount to be injected. The fuel injector is a solenoid-operated valve and the fuel injection amount is cont ...

See also:

Seat Heater Schematic Diagrams
Circuit Diagram ...

Replacement
When the receiver first arrives for replacement: 1) It will be in Virgin State. 2) It wi ...

Using CD Player
1. CD Button If the CD is loaded, turns to CD mode. If no CD, it displays No Media for 3 seconds and returns to the previous mode. 2. 1 Button (RANDOM) Press this button for less than 0.8 sec ...

Copyright www.kiopman.com 2020