ECM Problem Inspection Procedure
1.
TEST ECM GROUND CIRCUIT: Measure resistance between
ECM and chassis ground using the backside of ECM harness connector as
ECM side check point. If the problem is found, repa ...
Components and Components Location
Component Location
1. Rear defogger relay2. EWP relay3. Deicer relay4. ACC realy5. IG1 relay6. IG2 relay7. Wiper relay8. Rain sensor relay9. Burglar alarm horn relay10. Blower relay11. Fuel pump ...
Fuel Filler Door Open Switch. Repair procedures
Inspection
1.
Remove the driver door trim.
(Refer to the BD group - "Front door")
2.
Remove the switch assembly connector
(A) from the door trim.
...