Kia Optima: Front Impact Sensor (FIS) Repair procedures - SRSCM - RestraintKia Optima: Front Impact Sensor (FIS) Repair procedures

Removal
   
   
Removal of the airbag must be performed according to the precautions/ procedures described previously.
Before disconnecting the front impact sensor connector, disconnect the front airbag connector(s).
Do not turn the ignition switch ON and do not connect the battery cable while replacing the front impact sensor.
1.
Disconnect the battery negative cable, and wait for at least three minutes before beginning work.
2.
Remove the air duct (A).


3.
Loosen the radiator upper hose bolt (A).


4.
Remove the radiator mounting bracket (B).


5.
Disconnect the front impact sensor connector (A).


6.
Loosen the front impact sensor mounting nut (B) and remove the front impact sensor.
Installation
   
   
Do not turn the ignition switch ON and do not contact the battery cable while replacing the front impact sensor.
1.
Install the new front impact sensor.
2.
Tighten the front impact sensor mounting nut.

Tightening torque:
7.8 ~ 9.8 N.m (0.8 ~ 1.0 kgf.m, 5.8 ~ 7.2 lb-ft)

3.
Connect the front impact sensor connector.
4.
Install the radiator mounting bracket.

Tightening torque:
3.9 ~ 5.9 N.m (0.4 ~ 0.6 kgf.m, 2.9 ~ 4.3 lb-ft)

5.
Tighten the radiator upper hose bolt.
6.
Reconnect the battery negative cable.
7.
After installing the Front Impact Sensor, confirm proper system operation:
Turn the ignition switch ON; the SRS indicator light should be turned on for about six seconds and then go off.
Front Impact Sensor (FIS) Components and Components Location
Components ...

Side Impact Sensor (SIS) Description and Operation
Description Side Impact Sensor (SIS) system consists of two P-SIS which are installed at each center of the front door module (LH and RH) and two SIS which are installed at each center pillar n ...

See also:

Customer Complaint Analysis Check Sheet
There are several areas where a problem can occur: wiring harness, the radio, the CD player, and speaker. Troubleshooting enables you to confine the problem to a particular area. ...

Airbag Warning Label (sunvisor)
To remind you of the dangers of the airbag, airbag warning labels which are now required by the U.S. National Highway Traffic Safety Administration (NHTSA) are adhered to the drivers and passen ...

Intake Actuator Components and Components Location
Component Location ...

Copyright www.kiopman.com 2020