Emission Control SystemKia Optima: Emission Control System

Repair procedures
On-vehicle Inspection Spark Test 1. Disconnect the ignition coil connectors (A).     When disconnecting the ignition coil connector, pull out the locking pin (A) and ...

General Safety Information and Caution
Safety Precaution     Since hybrid vehicles contain a high voltage battery, if the high voltage system or vehicles are handled incorrectly, this might lead to a ser ...

See also:

Fuel Tank Repair procedures
Removal 1. Release the residual pressure in fuel line (Refer to “Release Residual Pressure in Fuel Line”). 2. Lift the vehicle. 3. Remove the front side cover (A) and rear side cover ( ...

Inspection
Remove the overhead console lamp assembly then check for continuity between terminals. If the continuity is not as specified, replace the map lamp switch. ...

TPMS Receiver Schematic Diagrams
Circuit Diagram Connector pin number Pin NO.DiscriptionRemark1-2-3ECU battery terminal4-5CAN_High6CAN_Low7-8-9Ground10-11-12-13-14-15-16-17-18Ignition ON19-20- ...

Copyright www.kiopman.com 2020