Kia Optima: Electric Oil Pump (EOP) Repair procedures - Hydraulic System - Automatic Transaxle SystemKia Optima: Electric Oil Pump (EOP) Repair procedures

Removal
1.
Disconnect the 12V battery negative (-) cable.
2.
Remove the under cover (A).

Tightening torque :
7.8 ~ 11.8 N.m (0.8 ~ 1.2 kgf.m, 5.8 ~ 8.7 lb-ft)


3.
Remove the electric oil pump (EOP) connector (A, B).


4.
Remove the EOP (A) after removing the bolt and nut.

Tightening torque :
42.2 ~ 53.9 N.m (4.3 ~ 5.5 kgf.m, 31.1 ~ 39.8 lb-ft)

Installation


Installation
1.
Install in the reverse order of removal.
   
   
вАҐ
Refill the automatic transaxle with fluid.
(Refer to Hydraulic System - "Fluid")
Electric Oil Pump (EOP) Components and Components Location
Component Location 1. Electric Oil Pump (EOP)2. Automatic transaxle ...

Oil Pump Uni t(OPU) Description and Operation
Description The oil pump main relay is installed within the HEV fusible link box of the engine room. When the Oil Pump Unit (OPU) triggers the oil pump main relay, electric current needed to op ...

See also:

Removal
1. Turn the ignition switch OFF and disconnect the battery negative (-) cable. 2. Disconnect the connector (A), and then remove the sensor (B). ...

Installation
1. Hold the timing chain, and place the intake CVVT & camshaft assembly. 2. Place the exhaust CVVT & camshaft assembly after releasing the ratchet of the timi ...

Glass antenna
When the radio power switch is turned on while the ignition key is in either the УONФ or УACCФ position, your car will receive both AM and FM broadcast signals through the antenna in the rear wi ...

Copyright © www.kiopman.com 2021