Kia Optima: Cylinder Head Components and Components Location - Cylinder Head Assembly - Engine Mechanical SystemKia Optima: Cylinder Head Components and Components Location

Components


1. Camshaft bearing cap
2. Camshaft front bearing cap
3. Exhaust camshaft
4. Intake camshaft
5. Exhaust CVVT assembly
6. Intake CVVT assembly
7. Exhaust camshaft upper bearing
8. Exhaust camshaft lower bearing
9. MLA (Mechanical lash adjuster)
10. Retainer lock
11. Retainer
12. Valve spring
13. Valve stem seal
14. Valve
15. Cylinder head
16. Intake OCV (Oil control valve)
17. Exhaust OCV (Oil control valve)
18. Cylinder head gasket

CVVT & Camshaft Repair procedures
Removal 1. Remove the cylinder head cover. 2. Set No.1 cylinder to TDC/compression. a. Turn the crankshaft pulley and align its groove with the timing mark "T" of the lower timing chain co ...

Cylinder Head Repair procedures
Removal     • Use fender covers to avoid damaging painted surfaces. • To avoid damaging the cylinder head, wait until the engine coolant temperature ...

See also:

Front Seat Components and Components Location
Components 1. Headrest2. Headrest guide3. Front seat back cover4. Front seat back warmer5. Front seat back frame6. Front seat duct7. Front seat back board8. Front seat cushion cover9. Front seat ...

Fender Repair procedures
Replacement     • Be careful not to damage the fender and body. • When removing the clips, use a clip remover. 1. Remove the front bumper. (Ref ...

Trailing Arm. Repair procedures
Replacement 1. Remove the rear wheel & tire. Tightening torque:88.3 ~ 107.9N.m (9.0 ~ 11.0kgf.m, 65.1 ~ 79.6lb-ft) ...

Copyright www.kiopman.com 2021