Kia Optima: CVVT Oil Control Valve (OCV) Repair procedures - Engine Control System - Engine Control/Fuel SystemKia Optima: CVVT Oil Control Valve (OCV) Repair procedures

Inspection
1.
Turn the ignition switch OFF.
2.
Disconnect the OCV connector.
3.
Measure resistance between the OCV terminals 1 and 2.
4.
Check that the resistance is within the specification.

Specification: 6.9 ~ 7.9? [20°C(68°F)]

Removal
1.
Turn the ignition switch OFF and disconnect the battery negative (-) terminal.
2.
Disconnect the CVVT oil control valve connector (A).
3.
Remove the mounting bolt (B), and then remove the valve from the engine.
[Bank 1 / Intake]

[Bank 1 / Exhaust]


[Bank 1 / Exhaust]

Installation


Installation
   
   
Install the component with the specified torques.
Note that internal damage may occur when the component is dropped. In this case, use it after inspecting.
Apply the engine oil to the valve O-ring.
1.
Install in the reverse order of removal.

CVVT oil control valve installation bolt:
9.8 ~ 11.8 N.m (1.0 ~ 1.2 kgf.m, 7.2 ~ 8.7 lb-ft)

CVVT Oil Control Valve (OCV) Schematic Diagrams
Circuit Diagram ...

NVLD(Natural Vacuum Leakage Detection) Description and Operation
Description NVLD(Natural Vacuum Leakage Detection) is located between the canister and the fuel tank air filter. NVLD is to detect leaks equivalent to a 0.5 mm hole in the fuel tank, canister a ...

See also:

Remote Fuel Filler Lid Release
Depress on the release button located on the drivers door to open the fuel filler lid. WARNING To avoid injury from sharp objects, it is recommended that protective gloves be worn when o ...

Heater & A/C Control Unit(Dual) Repair procedures
Self Diagnosis 1. Self-diagnosis process 2. How to read self-diagnostic code After the display panel flickers three times every 0.5 second, the corresponding fault code flickers on the setu ...

SS-B Solenoid Valve (ON/OFF) Repair procedures
Inspection 1. Turn ignition switch OFF. 2. Remove the air duct (A). Tightening torque: 7.8 ~ 9.8 N.m (0.8 ~ 1.0 kgf.m, 5.8 ~ 7.2 lb-ft) 3. Remove the air cleaner assembly. (1) Di ...

Copyright www.kiopman.com 2021