Kia Optima: Cruise Control Switch Repair procedures
Removal and Installation
1.
Disconnect the battery negative terminal.
Tightening torque :
4.0 ~ 6.0N.m (0.4 ~ 0.6kgf.m, 3.0 ~ 4.4lb-ft)
2.
Remove the driver airbag module. (Refer to the RT group - "Airbag module")
3.
Remove the steering wheel. (Refer to the ST group - "Steering column and shaft")
4.
Remove the steering wheel cover (A) after loosening the screws.
5.
loosening the screws at rear side of switch.
6.
Disconnect the cruise control switch connector and then remove the switch (A).
Be careful not to damage the hook when removing the switch.
7.
Installation is the reverse of removal.
Inspection
Measuring Resistance
1.
Disconnect the cruise control switch connector from the control switch.
2.
Measure resistance between terminals on the control switch when each function switch is ON (switch is depressed).
Function switch
Terminal
Resistance
CANCEL
2 - 7
180? ± 5%
SET/–
2 - 7
330? ± 5%
RES/+
2 - 7
550? ± 5%
ON/OFF
2 - 7
880? ± 5%
3.
If not within specification, replace switch.
Measuring Voltage
1.
Connect the cruise control switch connector to the control switch.
2.
With ignition switch ON, measure voltage between terminals on
the harnessside connector when each function switch is ON (switch is
depressed).
Function switch
Terminal
Voltage
CANCEL
2 - 7
0.67 ~ 0.86V
SET/–
2 - 7
1.10 ~ 1.39V
RES/+
2 - 7
1.59 ~ 1.97V
ON/OFF
2 - 7
2.13 ~ 2.56V
3.
If not within specification, inspect the control switch
resistance. The measuring resistance value is not within specification,
replace the switch and measure the voltage again.
4.
If resistance is OK but, measuring voltage is not within
specification, inspect the wiring harness and connectors between the
switch and the instrument cluster .
Curtain Airbag (CAB) Module. Description and Operation
Description
Curtain airbags are installed inside the headliner (LH and RH) and protect the driver
and passenger from danger when side crash occurs. The SRSCM determines deployment
of curtain airb ...
Radiator. Components and Components Location
Components
1. Cooling fan assembly
2. Radiator
3. Mounting insulator
4. Radiator mounting bracket
5. Radiator upper hose
6. Radiator lower hose
7. Res ...