Kia Optima: Canister Close Valve (CCV) Repair procedures - Engine Control System - Engine Control/Fuel SystemKia Optima: Canister Close Valve (CCV) Repair procedures

Removal
1.
Turn the ignition switch OFF and disconnect the battery negative (-) terminal.
2.
Lift the vehicle.
3.
Disconnect the canister close valve connector (A).
4.
Disconnect the ventilation hose (B) from the fuel tank air filter and canister close valve.
5.
Remove the fuel tank air filter assembly after removing bolts (C).


6.
Release the lever (A), and then separate the canister close valve (B) from the fuel tank air filter (C) after rotating it in the direction of the arrow in the figure.

Installation

Installation


Installation
   
   
Install the component with the specified torques.
Note that internal damage may occur when the component is dropped. In this case, use it after inspecting.
1.
Install in the reverse order of removal.
Canister Close Valve (CCV) Schematic Diagrams
Circuit Diagram ...

Fuel Delivery System
...

See also:

Power Windows
The ignition switch must be in the ON position for power windows to operate. Each door has a power window switch that controls that doors window. However, the driver has a power window switch whi ...

Components and Components Location
Component Location 1. Slide motor 2. Front height motor 3. Rear height motor 4. Lumber support motor 5. Power seat control switch 6. Recline motor 7. Reclin ...

Replacement
1. Recover the refrigerant with a recovery/ recycling/ charging station. 2. Disconnect the negative (-) battery terminal. 3. Remove the discharge line ...

Copyright www.kiopman.com 2020