Kia Optima: Camshaft Position Sensor (CMPS) Repair procedures - Engine Control System - Engine Control/Fuel SystemKia Optima: Camshaft Position Sensor (CMPS) Repair procedures

Inspection
1.
Check the signal waveform of the CMPS and CKPS using the GDS.

Specification: Refer to “Wave Form”

Removal
   
   
Do not remove the camshaft position sensor while engine is running or right after engine stops, or a scald by the flowed out engine oil may occur.
[Bank 1 / Intake]
1.
Turn the ignition switch OFF and disconnect the battery negative (-) terminal.
2.
Disconnect the camshaft position sensor connector (A).
3.
Remove the mounting bolt (B), and then remove the sensor.


[Bank 1 / Exhaust]
1.
Turn the ignition switch OFF and disconnect the battery negative (-) terminal.
2.
Disconnect the camshaft position sensor connector (A).
3.
Remove the hanger and the protector.
4.
Remove the mounting bolt (B), and then remove the sensor.

Installation


Installation
   
   
Install the component with the specified torques.
Note that internal damage may occur when the component is dropped. In this case, use it after inspecting.
Apply the engine oil to the O-ring.
Insert the sensor in the installation hole and be careful not to damage when installation.
Be careful not to damage the sensor housing and the connector.
Be careful not to damage the O-ring.
1.
Install in the reverse order of removal.

Camshaft position sensor mounting bolt:
9.8 ~ 11.8 N.m (1.0 ~ 1.2 kgf.m, 7.2 ~ 8.7 lb-ft)

Camshaft Position Sensor (CMPS) Schematic Diagrams
Circuit Diagram ...

Knock Sensor (KS) Description and Operation
Description Knocking is a phenomenon characterized by undesirable vibration and noise and can cause engine damage. Knock Sensor (KS) is installed on the cylinder block and senses engine knockin ...

See also:

Fuel Pressure Control Valve. Description and Operation
Description Fuel Pressure Regulator Valve is installed on the high pressure fuel pump and controls fuel flow flowing into the injectors in accordance with the ECM signal calculated based on var ...

Weight Classification System (WCS) Repair procedures
Removal 1. Disconnect the battery negative cable, and wait for at least three minutes before beginning work. 2. Remove the front passenger seat assembly. (Refer to the Body group - "Seat") ...

General Safety Information and Caution
Safety Precaution     Since hybrid vehicles contain a high voltage battery, if the high voltage system or vehicles are handled incorrectly, this might lead to a ser ...

Copyright www.kiopman.com 2020