Kia Optima Manuals

Kia Optima: Blind Spot Detection Unit Repair procedures - Blind Spot Detection System - Body Electrical SystemKia Optima: Blind Spot Detection Unit Repair procedures

Removal
Blind spot detection (BSD) unit
1.
Disconnect the negative (-) battery.
   
   
Be careful when removing the blind spot detection unit. The bracket may break off from the bumper.
2.
Remove the rear bumper.
(Refer to Body - "Rear Bumper Cover")
3.
Disconnect the BSD connector (A) from the BSD unit.


4.
Remove the BSD assembly (A) after loosening the mounting screws and fasteners.


5.
Remove the BSD unit (A) after loosening the mounting screws.


   
   
When removing the BSD unit, separate the fixed clip from the connector.
Installation
Blind spot detection (BSD) unit
1.
Ready the radar sensor RH and LH for each side properly.
2.
Install the radar sensor to the bracket correctly (distinguish RH & LH) with mounting nuts.
   
   
The shape of the left and right blind spot detection unit is different. Therefore, take notice when installing the blind spot detection unit.
Radar Sensors must be closed up against the bracket completely.
After mounting radar sensors, check a wobble.
3.
Connecto the negative (-) battery terminal.

Left side (Slave)
Right side (Master)
Shape


Remark
The location of the bracket is different.


4.
When replacing the BSD unit , you have to input the detailed regional information into the BSD unit. This learning process is called variant coding.
   
   
Follow the procedures which describes on the GDS screen.
Blind Spot Detection Unit Schematic Diagrams
Circuit Diagram ...

Blind Spot Detection Variant Coding Description and Operation
Description The used radar frequency of BSD is two, "North America region" and "Except North America region". If it replaces BSD unit, BSD unit has to perform the procedure of variant coding. BSD ...

See also:

Knock Sensor (KS) Schematic Diagrams
Circuit Diagram ...

Windshield Wiper Blade Replacement
When the wipers no longer clean adequately, the blades may be worn or cracked, and require replacement. ✽ NOTICE To prevent damage to the wiper blades, do not use gasoline, kerosene, paint ...

Rearview camera
The rearview camera will activate when the back-up light is ON with the ignition switch ON and the shift lever in the R position. This system is a supplemental system that shows behind the vehi ...

Categories

Kia Optima Manuals

Copyright © www.kiopman.com 2021