Kia Optima: AVN Head Unit Repair procedures - AVN System - Body Electrical SystemKia Optima: AVN Head Unit Repair procedures

Removal
AVN Head Unit
   
   
Take care not to scratch the center fascia panel and related parts.
Eject all the disc before removing the AVN head unit to prevent damaging the CD player''s load mechanism.
1.
Disconnect the negative (-) battery terminal.
2.
Using a screwdriver or remover, remove the crash pad side cover (A).


3.
After loosening the crash pad lower panel mounting screws, then remove the lower panel (A).


4.
Remove the switch connector (A) and SSB connector (B) from crash pad lower panel.


5.
Remove the crash pad garnish LH (A) after removing the screws.


6.
Using a screwdriver or remover, remove the crash pad garnish RH (A).


   
   
Apply the protective tapes to crash pad garnish and its related parts.
7.
Remove the instrument cluster fascia panel (A) after loosening the screws.


8.
Remove the center fascia lower panel (A) after loosening the screws.


9.
Remove the connectors (A) and hose (B).


10.
Remove the center fascia upper panel (A) after loosening the screws.


11.
Remove the AVN head unit assembly (A) after loosening the mounting screws.


12.
Disconnect the audio connectors and cable (A), then remove the audio unit completely.


   
   
Lift the connector locking clip to the arrow direction, disconnect the connector.
When assembling, install the connector and connector locking clip.
   
   
If the CD does not eject, do not attempt to remove it because the audio unit may be damaged.Contact an authorized hyundai dealership for assistance.
   
   
If the CD-rom needs to be removed, follow the procedure below.
Roof Antenna (GPS + SIRIUS)
1.
Remove the rear roof trim.
(Refer to the BD group - "Roof trim")
2.
Disconnect the connector and cable (A) from the roof antenna.


3.
Remove the roof antenna (A) after removing a nut

Installation


Installation
AVN Head Unit
1.
Connect the audio unit connectors and cables.
2.
Install the AVN head unit.
3.
Install the center fascia upper panel.
4.
Install the heater control unit.
5.
Install the crash pad garnish LH/RH and instrument cluster fascia panel.
6.
Install the crash pad lower panel and side cover.
   
   
Make sure the AVN head unit connectors are plugged in properly and the antenna cable is connected properly.
Roof Antenna (GPS + SIRIUS)
1.
Installation the roof antenna.
2.
Connect the connector and cable.
3.
Install the rear roof trim.
   
   
Make sure that the cables and connectors are plugged in properly.
Check the AVN system.
AVN Head Unit Components and Components Location
Components AVN (A/V & Navigation) Head Unit Connector Connecotr Pin Information No.Connector A (18pin)Connector B (24pin)Connector C (24pin)1-MM CAN highC CAN (-)2--C CAN (+)3---4-Steerin ...

Multimedia Jack Schematic Diagrams
Circuit Diagram ...

See also:

Inflation Pressures
All tire pressures (including the spare) should be checked monthly when the tires are cold. Cold Tires means the vehicle has not been driven for at least three hours or driven less than one mile ...

Installation
1. Install the power window switch module. 2. Install the door trim panel after reconnecting the relevant connectors ...

Removal
1. Turn the ignition switch OFF and disconnect the battery negative (-) cable. 2. Remove the resonator and the air intake hose (Refer to Intake And Exhaust ...

Copyright www.kiopman.com 2021