Kia Optima: Auto Light Sensor Repair procedures - Auto Lighting Control System - Body Electrical SystemKia Optima: Auto Light Sensor Repair procedures

Inspection
In the state of IGN1 ON, when multi function switch module detects auto light switch on, tail lamp relay output and head lamp low relay output are controlled according to auto light sensor''s input.
The auto light control doesn''t work if the pin sunlight supply (5V regulated power from Ignition 1 power to sunlight sensor) is in short circuit with the ground.
If IGN1 ON, The BCM monitors the range of this supply and raises up a failure as soon as the supply’s voltage is out of range. Then this failure occurs and as long as this is present, the head lamp must be turned on without taking care about the sunlight level provided by the sensor.
This is designed to prevent any head lamp cut off when the failure occurs during the night.
Removal
1.
Disconnect the negative (-) battery terminal.
2.
Remove the auto light sensor (A) from crash pad upper side by using screw (-) driver.


   
   
Apply the protective tapes to auto light sensor and its related parts.
3.
Remove the auto light connector.
Installation
1.
Reconnect the auto light connector.
2.
Install the auto light sensor.
Auto Light Switch Repair procedures
Inspection Lighting Switch Inspection With the multi function switch in each position, make sure that continuity exists between the terminals below. If continuity is not as specified, replace ...

Auto Head Lamp Leveling Device
...

See also:

Mode selection
The mode selection button controls the direction of the air flow through the ventilation system. Every time you press the mode selection button, the mode will change as follows: Refer to the i ...

Owner maintenance
The following lists are vehicle checks and inspections that should be performed by the owner or an authorized Kia dealer at the frequencies indicated to help ensure safe, dependable operation ...

Panoramaroof Switch. Repair procedures
Inspection 1. Disconnect the negative (-) battery terminal. 2. Remove the overhead console lamp assembly.(Refer to the BD group - "Roof trim") ...

Copyright © www.kiopman.com 2021