Kia Optima: Accelerator Pedal Repair procedures - Fuel Delivery System - Engine Control/Fuel SystemKia Optima: Accelerator Pedal Repair procedures

Removal
1.
Turn the ignition switch OFF and disconnect the negative (-) battery terminal.
2.
Disconnect the accelerator position sensor connector (A).


3.
Remove the mounting nuts (B) and bolt (C), and then remove the accelerator pedal module.

Installation

Installation


Installation
1.
Install in the reverse order of removal.

Accelerator pedal module mounting bolt:
8.8 ~ 13.7 N.m (0.9 ~ 1.4 kgf.m, 6.5 ~ 10.1 lb-ft)
Accelerator pedal module mounting nut:
9.8 ~ 14.7 N.m (1.0 ~ 1.5 kgf.m, 7.2 ~ 10.9 lb-ft)

Filler-Neck Assembly Repair procedures
Removal 1. Lift the vehicle. 2. Disconnect the fuel filler hose (A). 3. Disconnect the ventilation hose (B) from the fuel tank air filter. 4. Open the fuel filler door and then remove ...

Delivery Pipe Repair procedures
Removal 1. Turn the ignition switch OFF and disconnect the battery negative (-) terminal. 2. Release the residual pressure in fuel line (Refer to “Release Residual Pressure in Fuel Line” ...

See also:

Body Control Module (BCM) Components and Components Location
Components Connector Pin Information No.Connector A (24pin)Connector B (20pin)Connector C (24pin)1Battery (+)Head lamp low beam switchRoom lamp2IGN 1Head lamp high beam switchAV tail signal3IGN ...

Side Impact Sensor (SIS). Description and Operation
Description Side Impact Sensor (SIS) system consists of two P-SIS which are installed at each center of the front door module (LH and RH) and two SIS which are installed at each center pillar nea ...

Tilting the sunroof
When the sunshade is closed If you push the sunroof control lever upward, the sunshade will slide all the way open then the sunroof glass will tilt. To stop the sunroof movement at any point, p ...

Copyright www.kiopman.com 2020