Kia Optima: 35R Clutch Control Solenoid Valve (35R/C_VFS) Repair procedures - Automatic Transaxle Control System - Automatic Transaxle SystemKia Optima: 35R Clutch Control Solenoid Valve (35R/C_VFS) Repair procedures

Inspection
1.
Turn ignition switch OFF.
2.
Remove the air duct (A).

Tightening torque:
7.8 ~ 9.8 N.m (0.8 ~ 1.0 kgf.m, 5.8 ~ 7.2 lb-ft)


3.
Remove the air cleaner assembly.
(1)
Disconnect the breather hose (A).
(2)
Disconnect the air intake hose (B) and then remove the air cleaner assembly (C).

Tightening torque:
Hose clamp bolt:
2.9 ~ 4.9 N.m (0.3 ~ 0.5 kgf.m, 2.2 ~ 3.6 lb-ft)
Air cleaner assembly bolts:
7.8 ~ 9.8 N.m (0.8 ~ 1.0 kgf.m, 5.8 ~ 7.2 lb-ft)


   
   
When installing the air intake hose, the plate of the hose clamp must be in line with the stopper of the hose.
When installing the air intake hose, the center of the mark of hose must be in line with the throttle body rib.


4.
Remove the solenoid valve connector (A).


5.
Measure resistance between signal terminal and ground terminal.
6.
Check that the resistance is within the specification.
Removal
   
   
Replacing an on/off solenoid valve (SS-A, SS-B) does not require additional hydraulic pressure adjustment; however, the hydraulic pressure will need to be adjusted after replacing the VFS solenoid valve. If replacing the VFS solenoid valve; also replace the valve body assembly.
(Refer to Hydraulic System - "Valve Body")
35R Clutch Control Solenoid Valve (35R/C_VFS) Schematic Diagrams
Circuit Diagram ...

Underdrive Brake Control Solenoid Valve (UD/B_VFS) Description and Operation
Description Underdrive brake control solenoid valve(UD/B_VFS) is attached to the valve body. This variable force solenoid valve directly controls the hydraulic pressure to the underdrive brake. ...

See also:

Inspection
1. Turn the ignition switch OFF and disconnect the battery negative (-) cable. 2. Disconnect the fuel pressure regulator valve connector. 3. ...

Electronic Parking Brake (EPB). Description and Operation
Description The EPB is an electronic parking brake. The EPB is different from existing parking systems which operated with the brake pedal or the lever type. The EPB system sends the signal to th ...

Removal
Rear Combination lamp (Outside) 1. Disconnect the negative (-) battery terminal. 2. Remove the rear combination lamp cover (A). 3. Replace the ...

Copyright www.kiopman.com 2021